GE AJEM 10 Owner's Manual And Installation Instructions page 5

Cool Mode
Remote Control
1. Press Cool pad.
2. Press Low, Med or High pads to set desired fan speed.
3. Press the Increase +/ Decrease – pads to set the desired
temperature 60°F to 85°F in 1°F increments.
Control Panel
1. Press the Mode pad until the Cool indicator light is lit and the Low,
Med or High indicator light is lit for the desired fan speed.
2. Press the Increase + / Decrease – pads to set the desired
temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature. The
compressor will cycle on and off to keep the room at the set level of
comfort. Set the thermostat at a lower number and the indoor air will
become cooler.
FAN MODE
Use the Fan mode to provide air circulation and filtering without
cooling. Since fan-only settings do not provide cooling, a temperature
setting will not be displayed.
Set the thermostat at a higher number and the indoor air will become
warmer.
NOTE: If the air conditioner is off and is then turned on while set to
Cool, it will take approximately 3 minutes for the compressor to start
and cooling to begin.
Cooling Descriptions
Select the Cool mode and High or Med fan with
a middle set temperature.
Select the Cool mode and HIGH fan with a
lower set temperature.
fan with a middle set temperature.
NOTE: If you switch from a Cool setting to Off or to a fan setting,
wait at least 3 minutes before switching back to a Cool setting.
Remote Control
Press Fan pad. Press Low, Med or High pads to set desired fan speed.
Control Panel
Press the Mode pad until the Fan indicator light is lit and the Low, Med
or High indicator light is lit for the desired fan speed.
Select the Cool mode and Low
5