Installation - Electrolux EQT4520BOZ User Manual

Problem
The hob deactivates.
Residual heat indicator
does not come on.
There is no signal when you
touch the panel sensor
fields.
comes on.
comes on.
and a number come on. There is an error in the hob. Disconnect the hob from
comes on.
comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also three
digit letter code for the glass ceramic (it is
in the corner of the glass surface) and an

8. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
You put something on the
sensor field .
The zone is not hot be-
cause it operated only for a
short time.
The signals are deactivated. Activate the signals.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
The electrical connection is
incorrect. The supply volt-
age is out of range.
The cooling fan is blocked.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
8.1 Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
ENGLISH
Remedy
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot,
speak to an Authorised
Service Centre.
Refer to "Daily use" chapter.
Deactivate the hob and ac-
tivate it again.
Refer to "Daily use" chapter.
the electrical supply for
some time. Disconnect the
fuse from the electrical sys-
tem of the house. Connect
it again. If comes on
again, speak to an Author-
ised Service Centre.
Speak to a qualified electri-
cian to check the installa-
tion.
Check if objects block the
cooling fan. If comes
on again, speak to an Au-
thorised Service Centre.
15