Advertisement
3.
If low heat is required, release the button. The button will automatically spring
up to the low heat position shown in figure 2
(See note i below).
4.
For a higher heat level slide the button upwards. The burner flames and heat
output will gradually increase until the button reaches the high heat position shown in
figure 2. When the button reaches the high heat position you will feel a check to its
movement. Do not slide the button above the high heat position unless you want to
turn the fire off (See note i below).
Note
i) If the flames go out while setting the control, repeat the full lighting procedure. If
the flames repeatedly go out have the fire serviced.
ii) Please note. When first turned on the flames will appear predominantly blue. The
coals will take time to warm up. Although some glow will be seen after
approximately ten minutes, the full visual effect will only be apparent after a
somewhat longer time.
iii) The appliance will operate to its maximum potential if the flue is primed during
the first 20 – 30 minutes of operation.To do this, simply slide the control button to
its highest setting. This will also burn off any carbon deposits that may have
formed during previous operations.
iv) If operating the appliance for long periods it is beneficial occasionaly to change
the settings. This will also help to remove any carbon deposits that may form
during operation.
To turn the fire off
Slide the button up past the high heat position to the "O" position.
Both the main burner and the pilot should go out.
While cooling, the coals may make some crackling noises.
This is quite normal.
Lighting with a taper
In the unlikely event of failure of the ignition spark, the
pilot can be lit by a taper or long spill. Insert the taper or
spill alongside of the left side of the fire box and operate
the slide control as described above. See figure 3.
OWNER'S GUIDE
Page 7
Fig. 3 Lighting with a
taper
Hide quick links:
Advertisement
