GE JGRS14 Use And Care Manual page 7

OVEN CONTROL, CLOCK AND TIMER
Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
Baking cycle.
Timer
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 55
minutes.
To Reset the Timer
If "TIMER" is displayed, press the INCREASE or
DECREASE pad until desired time is reached.
If "TIMER" is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
The end of cycle tone is three short beeps followed by
one beep that repeats every six seconds until you
press any operation. If you would like to eliminate the
repeating beeps, press and hold the CLEAR/OFF pad
for 10 seconds.
To Set the Clock
1. Press the
CLOCK pad.
CLOCK
To Set the Timer
1. Press the TIMER
ON/OFF pad.
TIMER
ON/OFF
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad.
To Cancel the Timer
Press and hold the TIMER ON/OFF pad until the
word "TIMER" disappears from the display.
Power Outage
After a power outage, when power is restored, the
display will flash and time shown will no longer be
correct—for example, after a 5-minute power
interruption the clock will be 5 minutes slow. The
display flashes until the clock is set.
All other functions that were in operation when the
power went out will have to be programmed again.
2. Press the INCREASE
or DECREASE pad
to set the time of day.
The timer, as you are setting it, will
display seconds until one minute is
reached.
Then it will display minutes and
seconds until 60 minutes is reached.
After 60 minutes, it will display
hours ("HR" now appears in display)
and minutes until the maximum
time of 9 hours and 55 minutes
is reached.
7