Troubleshooting; Technical Specifications - Saeco A MODO MIO premium Operating Instructions Manual

EN
Problems
The machine does not turn on.
EXTRA: power light
is off after having
turned the machine ON and waited for
a few minutes.
PREMIUM: the brew lights
and are
not blinking.
The machine requires a lot of time to
heat up.
The pump is very noisy.
The loading lever doesn't reach the
brewing position.
The coffee is cold.
The coffee is brewed too fast, the
brewed coffee is not creamy.
The coffee is not brewed and some steam
comes out from the pod compartment.
Coffee is not brewed or brewed in
drips only.
The pods, after they have been used,
have holes only on the upper film.
Hot water/steam not dispensed.
The milk does not froth.
Please contact a Saeco authorized service center for any faults not covered in the above table or when the suggested solutions do not solve the

TECHNICAL SPECIFICATIONS

· Nominal Voltage - Power Rating - Power Supply: See label on
the appliance
· Dimensions:
Height Width
12" (305 mm) 9.25" (235 mm)
· Weight: about 11 lbs. (5 kg)
· Water tank: 34 oz. (1 lt.) - Removable type
· Housing Material: ABS - Thermoplastic

TROUBLESHOOTING

Causes
» The machine is not connected to
the power source.
» The machine has limescale
build-up.
» No water in the tank.
» Circuit is not primed.
» Dregdrawer full.
» Pod inserted incorrectly.
EXTRA:
» the brew light was
off when the brew button was
pressed.
» Pod already used.
» The loading lever was not set to
the brewing position.
» Dispensing spout is clogged.
» Circuit is not primed.
» Circuit is not primed.
» Hot water/steam wand is clogged.
» Not suitable milk.
» The milk is too hot.
EXTRA: the steam light
» was off
when the steam was dispensed.
problem.
· Power Cord Length: 47" (1.2 m)
· Control Panel: Top of machine
· Boiler: Stainless steel
Depth · Safety Devices: Boiler pressure safety valve
13" (330 mm) · Thermal fuse (EXTRA and PREMIUM versions)
· Safety thermostat (PREMIUM version)
2006/42 CE - 2004/108 CE - 2006/95 CE
Solutions
» Connect the machine to the power source.
» Contact Saeco customer service.
» Descale the machine.
» The tank with fresh drinking water.
» Prime the water circuit.
» Empty out the dregdrawer.
» Repeat the sequence, lever in the off posi-
tion, lever in the brewing position; if that
is not enough remove the pod manually
from the compartment after unplugging
the machine.
» Wait until the indicator light turns on.
» Place the lever back in the off position and
insert a new pod.
» Set the loading lever to the brewing
position.
» Clean the dispensing spout.
» Prime the water circuit.
» Prime the water circuit.
» Clean the wand with a needle (the
machine needs to be unplugged and the
steam/hot water knob needs to be closed).
» Use fresh, partially skimmed milk.
» Use milk at refrigerator temperature.
EXTRA:
» keep pressing the steam button
until the indicator light turns on.