4. Remove the coin-cell battery as shown.
Figure 33. Removing the coin-cell battery
5. Install the new coin-cell battery as shown.
Figure 34. Installing the coin-cell battery
6. Reinstall the computer cover and connect the cables. See "Completing the parts replacement" on
page 70.
7. Turn on the computer and all connected devices.
Note: When the computer is turned on for the first time after replacing the coin-cell battery, an error
message might be displayed. This is normal after replacing the coin-cell battery.
8. Use the Setup Utility program to set the date, time, and any passwords. See "Using the Setup Utility
program" on page 33.
Completing the parts replacement
After completing the installation or replacement for all parts, reinstall the computer cover and reconnect
cables. Depending on the parts you installed or replaced, you might need to confirm the updated information
in the Setup Utility program. Refer to "Using the Setup Utility program" on page 33.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your computer. See "Computer components" on page 6 for the locations of various components
in your computer.
2. Ensure that the cables are routed correctly before reinstalling the computer cover. Keep cables clear of
the hinges and sides of the computer chassis to avoid interference with reinstalling the computer cover.
70
ThinkCentre M700 User Guide