Replacing The Front Bezel - Lenovo thinkcentre M700 User Manual

6. Align the notch 1 on the new M.2 solid-state drive with the slot key
solid-state drive into the M.2 slot until it is secured tightly so that the notch
corresponding screw hole in the adapter. Install the screw to secure the solid-state drive.
Figure 20. Installing the M.2 solid-state drive
7. Reinstall the M.2 solid-state drive adapter. See "Replacing a PCI Express card" on page 65.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 70.

Replacing the front bezel

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
To replace the front bezel, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 52.
2 in the M.2 slot. Then, insert the
3 is aligned with the
.
Chapter 7 Installing or replacing hardware
59