Assembly; Operation - Porter-Cable 7499 Instruction Manual

NOTE: This tool is shipped completely assembled. No assembly time
or tools are required.
TO START AND STOP MOTOR
The Cutout Tool is equipped with a
"rocker" type switch (A) Fig. 1, labeled
"OFF" on one end and "ON" on the
other.
To ensure that the tool is "OFF",
1.
depress the "OFF" end of the switch
button. Make sure that the power
circuit voltage is the same as that
shown on the specification plate.
2. Connect the tool to the power circuit.
torque. Make sure that the bit is clear of the workpiece and foreign objects.
Depress the "ON" end of the switch button to start the motor.
3.
4. When you complete the cut, lift the tool clear of the workpiece and depress
the "OFF" end of the switch button to stop the motor.
putting it down.
SELECTING THE BIT
A variety of cutout bits are available. Refer to the listing in your Porter-Cable
Catalog to select the bit that is best suited to your application.
INSTALLING AND REMOVING THE BIT
The Model 7499 Cutout Tool is designed
to accept cutout bits with either .115",
1/8", or 1/4" diameter shanks. Insert bits
with 1/4" shanks directly into the spindle
shaft of the Cutout Tool. Secure the bits
with the screw (A) Fig. 2.

ASSEMBLY

OPERATION

G r a s p t h e m o t o r
f i r m l y t o r e s i s t
To avoid personal injury or damage to finished work,
always allow the motor to come to a complete stop before
Be sure that the power switch is in the "OFF" position and
that the machine is disconnected from the power source.
A
9
A
Fig. 1
Fig. 2