Table of Contents
Advertisement
A
INSTALLING A BIT WITH 1/4" SHANK
"OFF" position and that the tool is
disconnected from the power source
to avoid accidental starting which
could result in personal injury.
1.
Clean and insert a bit shank into the
Cutout Tool spindle (Fig. 6). The bit
shank must extend at least 1/2" into
the spindle.
2.
Engage the spindle lock (B) Fig. 5.
3.
Firmly tighten the screw (A) Fig. 6.
INSTALLING A BIT WITH .115" OR 1.8" SHANK
accidental starting which could result
in personal injury.
1.
Clean and insert the shank of the
special chuck into the spindle until it
bottoms (Fig. 7)
NOTE: To minimize vibration levels, insert
the special chuck with setscrew (B) Fig. 7
180º from the shaft set screw (A).
A
B
Fig. 3
Be sure the power
s w i t c h i s i n t h e
Be sure the power switch is in the "OFF" position and that
the tool is disconnected from the power source to avoid
Fig. 4
A
B
10
B
Fig. 5
Fig. 6
A
Hide quick links:
Advertisement
Table of Contents
