Assembly And Operating; Changing Sanding Sleeve On Roller; Variable Speed Control - Porter-Cable PXRA2676 Owner's Manual

CHANGING SANDING SLEEVE ON ROLLER

WARNING:
!
Remove the plug from the
power source before installing or removing a
sanding roller.
1. Lift the two roller end cover hasps (1) away
from the main housing (2) (Fig. 1).
2
1
3
2. Release the RIGHT hasp from the roller
end cover (3).
3. Pull the cover out from the main housing
and flip it toward the front of the tool using
the LEFT hasp as a hinge (Fig 2).
4. Slide the roller (4) off the roller shaft (5).
Fig. 2
5. Remove the old sanding sleeve and slide
the new sanding sleeve (6) onto the roller
(4) (Fig. 3).
NOTE: Rotate the roller sleeve counter-
clockwise as you slide the roller sleeve fully
onto the roller. Make sure it is centered on
the roller and is not overhanging one end
of the roller.

ASSEMBLY AND OPERATING

Fig. 1
1
6. Slide the roller onto the roller shaft (Fig. 4).
NOTE: The roller can only be installed one
way. When properly installed, the
directional arrow (7) on the end of the roller
will be visible.
7. Reinstall the roller end cover and fasten it
in place with the two roller end cover
hasps.
CAUTION: Make sure the roller end cover
is properly seated onto the main housing
and the hasps snap into place.

VARIABLE SPEED CONTROL

The variable speed control (1) can be rotated to
change the speed at which the roller will rotate
(Fig. 5). Rotate the speed control to the LEFT
(#1) for slowest speed and to the right (MAX) for
the fastest speed.
NOTE: See "SANDING" section of this manual
for recommended speeds.
11
6
4
Fig. 3
7
Fig. 4