Peak PAC Auto PAC 300 Operation Manual page 28

If Cam Follower ○
stops beyond the correct position:
41
Please also loosen the M6 screws but turn the Cam Roller slightly counterclockwise until
○
41
the Cam Follower stops at the correct position.
○
33
Figure 2 shows the correct position for LS2 Proximity Sensor against the lobes of
○
34
the Limit Switch Cam while machine is running.
○
When LS2 Proximity Sensor detects Lobe A of the activated running Limit Switch
33
○
Cam , the machine will stop about 0.3 seconds so that the machine can switch to
34
○
take-up. In the meantime, Cam Follower has to stay on the corner position of the
41
○
Tension Cam as shown in figure 2-1. If the Cam Follower is not at the correct
42
position, please make the same adjustment as for LS3.
- 22 -