Feed And Take-Up Mechanism - Peak PAC Auto PAC 300 Operation Manual

(2) Feed and take-up mechanism

If this unit is not correctly adjusted, strap feed
and take-up will become irregular.
Normally, this unit is set to accept P.P. strap
with the thicknesses of 0.55mm-0.75mm. If a
different strap thickness is used, adjust the
section marked by a circle in the drawing so that
the clearance between the Upper Roller Spring
○
and the Upper Shaft Spring Hook
23
should be the thickness of the strap you are
using. Strap can only be taken up properly if
this unit is precisely adjusted. (If not, strap
will be sealed before being tightened around the
package) Moreover, strap will leave the chute
arch track when feeding into it if there is no
clearance.
a. Check if the control unit returns to its
original position. Insert the strap between
Feed Roller
○
.
21
b. Loosen 2 Bolts
Block Arm
Press Arm Shaft can then easily be moved by
hand.
c. Adjust so that there is a clearance between the
Upper Roller Spring
Spring Hook
the strap you are using.
d. Tighten 2 Bolts
○
and Upper Feed Roller
22
○
holding the right-hand
27
○
with the Press Arm Shaft
25
○
and the Upper Shaft
23
○
the same as the thickness of
24
○
.
27
○
24
○
.
26
The thickness of the
strap you are using
- 20 -