How To Adjust Ls3, Ls2 - Peak PAC Auto PAC 300 Operation Manual

(3) How to adjust LS3, LS2

Figure 1: LS-3 Home Position
Figure 1: LS-2
Take-up
Figure 1 shows the correct position for LS3 Proximity Sensor
○
Cam while the machine is in home position.
32
The machine will stop as soon as the LS3 Proximity Sensor
○
Cam is activated. At this time, the Cam Follower
32
position on the Tension Cam
to the following instructions.
Adjustment
If Cam Follower ○
a. Loosen the two M6 screws and turn the Cam Roller slightly clockwise, then tighten
the M6 screws.
b. Reset the machine and allow it to cycle again to ensure that the Cam Follower
stops at the correct position.
c. If the problem has not been eliminated, please repeat the "Step One" until the Cam
Follower
M6 screw
Cooling Time
Feeding
○
42
stops before the correct position:
41
○
41
stops at the correct position.
as shown in figure 1-1. If not, please adjust according
- 21 -
Figure 1-1
Cam Follower
Tension Cam
Figure 2-1
○
and the Limit Switch
31
○
detects that Limit Switch
31
○
must stop at the corner
41
○
41