HP E30 User Manual page 40

Chapter 5
resources there may be one value, or several values from which you may
select by configuring jumpers or switches on the board. A board may not
require resources from all of these categories. If the documentation for the
board does not reference some of these resources, they may not be
required, and need not be reserved.
CAUTION
Different boards cannot use the same resources. If two boards
require any of the same resources, reconfigure one of the
boards (via switches or jumpers on the board) so that the
boards have different resource requirements.
2. Turn on the power switch on your HP NetServer and display monitor.
3. When you see the message "F2 = Setup" on the display monitor, press the
F2 function key.
4. When the Setup screen is displayed, use the left and right arrow keys to
select the Configuration menu.
5. Use the down arrow key to select the ISA Non-Plug-and-Play Board option
from the menu, and press the Enter key.
6. Use the down arrow key to select the Memory Resources option from the
menu, and press the Enter key.
7. Use the up and down keys to select the memory block that corresponds to
the memory range required for the ISA board you are installing, and press
the F7 or F8 key to reserve that block. If the memory range required for a
board spans two or more blocks shown on the screen, reserve all blocks
required by the board. If the memory range required for the board is less
than one block, select the whole block that contains the range.
NOTE
Boards may share a reserved memory block as long as each
board uses a unique memory address range within the block.
No two boards may use the same memory address range.
Reserve memory blocks for all remaining ISA non-Plug-and-Play boards
you are installing.
8. Press the Escape key to return to the ISA Non-Plug-and-Play Boards menu.
9. Use the down arrow key to select the DMA Resources option from the
menu, and press the Enter key.
32
Accessories