4IPNET, INC. You may not alter or remove any copyright or other notice from copies of the content. All other brand and product names are claimed or registered marks of their respective companies or organizations.
Page 4
This declaration is only valid for configurations (combinations of software, firmware, and hardware) provided and supported by 4ipnet Inc. The use of software or firmware not provided and supported by 4ipnet Inc. may result in the equipment no longer being compliant with the regulatory requirements.
2. Quick Installation Guide (QIG) x 1 a rugged multi-mode MIMO outdoor access point 3. CD-ROM (with User’s Manual and QIG) (single radio for the OWL610, dual radio for the 4. Power Sourcing Equipment (PSE) X 1 OWL620), specifically designed...
For connecting to an antenna (RF Card A x 2, RF Card B x 2) *OWL610 has 2 N-type connectors to go with one built-in RF card. *OWL620 has 4 N-type connectors to go with the corresponding dual RF card.
Quick Installation Guide OWL600 Series Enterprise Access Point ENGLISH Hardware Installation The following diagram is a basic network topology which can be used for testing and configuring the OWL610 / OWL620. Installation Steps: Step 1. Connect an antenna to the connector.
1. To access the web management interface, connect the administrator PC to the LAN port of OWL610 / OWL620 via an Ethernet cable. Then, set a static IP address on the same subnet mask as OWL610 / OWL620 in TCP/IP of your PC, such as the following example: IP Address: 192.168.1.100...
Page 9
OWL600 Series Enterprise Access Point ENGLISH Administrator Login Page 4. After a successful login into OWL610 / OWL620’s Web user interface (Web UI), a System Overview page of web management interface will appear, as depicted below. The Web Management Interface - System Overview Page 5.
Page 12
OWL600 Series Enterprise Access Point ENGLISH VAP Configuration Page (VAP-1 shown) OWL610 / OWL620 supports up to 8 virtual APs per RF card (VAPs). Configure VAP profile settings: (a) Select the VAP Configuration tab to configure the settings of the desired VAP.
Page 14
ENGLISH Step 4. Configure WDS (Wireless Distribution System) Settings (Optional) To extend the wireless coverage, OWL610 / OWL620 supports up to 4 WDS links for connecting wirelessly to other WDS-capable APs (peer APs). By default, all WDS profiles are disabled.
Page 15
OWL600 Series Enterprise Access Point ENGLISH After OWL610 / OWL620's network configuration is completed, please remember to change the IP Address of your PC Connection Properties back to its original settings in order to ensure that your PC functions properly in its real network environments.