Pentair Fleck 6700XTR Service Manual page 13

3. Regenerant Flow
This program step selects how the regenerant flows through the tank (must match cam). The selections
available will vary depending on the previously chosen valve model..
— Press the Up or Down buttons to adjust this value.
— Press the Extra Cycle button..
.
.
.
.
4. Display Format
This program step selects the display format..
— Press the Up or Down buttons to adjust this value..
— Press the Extra Cycle button..
.
.
.
.
5. Unit Capacity
This program step selects the timer's total capacity of hardness that can be removed..
— Press the Shift button to select the digit you want to modify..
— Press the Up or Down buttons to adjust this value..
— Press the Extra Cycle button..
.
.
.
.
6. Feed Water (Hardness)
This program step is used to set the feed water hardness. The system will automatically calculate volume
remaining based on the unit capacity, capacity safety factor (reserve systems only), and feed water hardness
entered..
— Press the Shift button to select the digit you want to modify..
— Press the Up or Down buttons to adjust this value..
— Press the Extra Cycle button..
.
.
.
.
CAUTION: Before entering Master Programming, please contact your local professional water dealer.
Master Programming Mode
.
Page 13