Table of Contents
Advertisement
Connections
Turn off the power of all components before proceeding with the connections.
Transmitting system connections
Connect the control panel
OWhen an AW-RP301 or AW-RP501 is being used,
connect the receiving pan-tilt head system to the P1
CONTROL OUT connector.
OWhen an AW-RP505 or AW-RP605 is being used, it is
possible to select either P1, P2, P3, P4 or P5 for the
connected pan-tilt head system using the CONTROL
button on the controller.
When an AW-RP605 is used
AW-RP605
Control panel
Version 45 or higher of the software must be installed in
the AW-RP605.
Consult with your local dealer to check which software
version is currently installed.
Coaxial cable
(5C-2V)
10Base-T cable
Control
panel
AW-PS301
Set the control panel
selector switch to B.
AW-DU600
RS-232C cable
Modem
Telephone line
OWhen an AW-RP301, AW-RP501 or AW-RP505 is
being used as the controller, an AW-PH350 can not be
used as the pan-tilt head.
AW-RP605
Main unit
10Base-T cable
AW-DU600
Modem
Telephone line
6
AW-PS301
AC adapter
AW-PS505
AC adapter
AW-PS301
Set the control panel
selector switch to A.
Advertisement
Table of Contents
