Table of Contents
Advertisement
Menu settings
The following items are only displayed when this adapter is in Direct mode
Menu-4 Input
(Initial setting:RS-232C)
Menu-6 Output-2
(Initial setting: P1)
The following item is only displayed when this adapter is in Rx mode or Direct mode
Menu-5 Output-1
(Initial setting: RS-422)
$ Dial memory
This adapter's dial memory function enables up to 5 specific
telephone numbers to be stored.
Registering a telephone number
O
1. Enter the number using the operating keys on this
adapter.
2. While pressing the
key, press one of the dial memory
#
registration keys from
which the number is to be entered.
3. "Writing Memory 2" (2 is the dial memory number)
appears on the LCD panel and the telephone number is
stored.
This setting selects which connector is to be used for the controller when this adapter is in Direct mode.
RS-232C
TO RCB/PC connector (PC used for control)
RS-422
PAN/TILT CONTROL IN connector (control panel used for control)
This setting selects which pan-tilt head system is to be controlled by this adapter when this
adapter is in Direct mode.
The pan-tilt head system connected to the RS-232C or RS-422 P1 connector is
P1
controlled.
The pan-tilt head system connected to the RS-232C or RS-422 P2 connector is
P2
controlled.
The pan-tilt head system connected to the RS-232C or RS-422 P3 connector is
P3
controlled.
The pan-tilt head system connected to the RS-232C or RS-422 P4 connector is
P4
controlled.
The pan-tilt head system connected to the RS-232C or RS-422 P5 connector is
P5
controlled.
This setting selects which connectors are to be used for the pan-tilt head systems.
The RS-232C CONTROL OUT connectors are used.
RS-232C
The RS-422 connectors cannot be used in conjunction with these
connectors.
The RS-422 CONTROL OUT connectors are used.
RS-422
The RS-232C connectors cannot be used in conjunction with these
connectors.
(M1) through
(M5) into
1
5
Using a dial memory to make a call
O
1. Press the
RECALL
2. The dial memory number (M1 to M5) entered appears on
the LCD panel.
If a telephone numbers has not been registered for the
dial memory number, the LCD panel display will be blank.
3. Each time the
RECALL
pressed, the dial memory number is switched.
4. Press the
START
Erasing a dial memory
O
1. Press the
CLEAR
number displayed on the LCD panel.
2. While pressing the
#
registration keys from
to be erased.
3. "Writing Memory 2" (2 is the dial memory number)
appears on the LCD panel and the telephone number is
erased.
18
key (
).
#
STOP
i
key (
#
STOP
i
key to initiate the connection.
key (
) to erase the
#
START
i
key, press one of the dial memory
(M1) through
(M5) which is
1
5
) is
Advertisement
Table of Contents
