Table of Contents
Advertisement
Problem
"Fault: F 33" appears in
the display.
"; Fault: F XX" appears
in the display.
The message "Function
not available" appears
in the display after
selecting Moisture
plus d or the
"Descale" function.
The message "Fault with
moisture control - the
automatic programmes
will operate without
moisture" appears in the
display after selecting
an Automatic
programme.
Programmes using
moisture will not take in
water.
Possible cause and remedy
The door lock for the Pyrolytic cleaning programme is
not being released.
^ Switch the oven off and then back on again.
If the door lock still does not release itself call the Miele
Service Department.
There is a problem that you cannot resolve.
^ Call the Miele Service Department.
The steam injection system is faulty.
^ Call the Miele Service Department.
The steam injection system is faulty.
^ Call the Miele Service Department.
Automatic programmes can be run without using
moisture.
Demo mode is active.
The oven can be used in demo mode but the pump for
the steam injection system will not work.
^ Deactivate demo mode. See "Settings - Showroom
programme".
Problem solving guide
119
Advertisement
Table of Contents
