Initial Camcorder Setup - Vivitar DVR 946HD User Manual

Initial Camcorder Setup

Flip open the LCD screen. When powering the camcorder ON for the first time the camcorder will
take you through the initial camcorder setup.
POWERING THE CAMCORDER ON
1. Installing the Batteries
Make sure the batteries have been inserted properly into your digital camcorder, according to the
polarity shown inside the battery compartment.
Use 4 x AAA (1.5V) batteries. Alkaline batteries are recommended. Batteries not included.
Note:

Remove the batteries from the camcorder when not in use for an extended period.

Do not mix alkaline and non-alkaline batteries.

Some camcorder features (Flash) will not work if the battery power level is low.

When the battery power is low the battery icon turns red and the camcorder will automatically
turn off a few seconds later.

The energy status of the power is displayed on LCD as shown below:
Full battery power
Low battery power
2. Installing the SD Memory Card
Medium battery power
Recommended to Replace Batteries
4