Initial Camcorder Setup - Vivitar DVR 859HD User Manual

Initial Camcorder Setup

INSTALLING THE BATTERIES
Make sure the batteries have been inserted properly into your digital camera, according to the polarity
shown on the battery holding frame.
Use 3 x AAA (1.5V) batteries. Alkaline batteries are recommended. Batteries not included.
To Install the Batteries:
1) Slide open the battery/memory card compartment door.
2) Pull out the battery holding frame.
3) Insert 3 x AAA batteries into the battery holding frame according to the correct polarities as shown
in the photo above.
4) Slide the battery holding frame with the installed batteries into the battery compartment.
5) Close the door and slide back into place to securely close the battery/memory card compartment.
Note:
 Remove the batteries from the camera when not in use for an extended period.
 Do not mix alkaline and non-alkaline batteries.
 Some features will not work if the battery power level is low.
 Rechargeable batteries not recommended.
 When the battery power is empty the battery icon turns red and 'Low Battery' flashes on the
LCD screen. The camcorder automatically turns off a few seconds later.
 The energy status of the power is displayed on LCD as shown below:
Full battery power Medium battery power
4
Low battery power