Absolute Maximum Ratings; Phone Modes Of Operation - Nokia RM-42 Service Manual

Nokia Customer Care
OMAP3.3 consists of ARM926 (MPU subsystem), TMS320C55x (DSP subsystem), DMA and OMAP3.3s internal
peripherals.
Helen3s MPU subsystem is based on an ARM926EJ. MPU is able to perform most of the application operations
on the chip.
System DMA: This component is mainly used to help the MPU and DSP perform data memory transfer-specific
tasks, leaving more available MIPS for both processors.
The DSP subsystem is based on a TMS320C55x™ DSP core, which is responsible for intensive data computing
tasks like real-time audio and video handling on application side. E.g. voice recording.
Internal memory subsystem: This subsystem is composed of a single port SRAM.
Secure modules: OMAP1710 contains a set of several components, including ROM, a single port SRAM, and eFUSE
cells. These components enable the system to support secure applications.
Memory interfaces: The memory interfaces define the system memory access organization of OMAP1710.
USB & modem interface: These two modules enable the platform to support a universal serial link and a
dedicated modem interface, enabling a high data transfer rate between the modem and the application chip.
System components: System components are group of modules responsible for managing system interactions
such as interrupt, clock control and idle.
Peripheral subsystem: The peripheral subsystem defines all the components used to interface OMAP1710 with
specific external devices such as camera, keyboard, display etc.

Absolute maximum ratings

Signal
Battery voltage (idle)
Battery voltage (Call)
Charger input voltage
Back-Up supply voltage

Phone modes of operation

Mode Description
NO_SUPPLY (dead) mode means that the main battery is not present or its voltage is too low (below
RETU master reset threshold) and that the back-up battery voltage is too low.
BACK_UP The main battery is not present or its voltage is too low but back-up battery voltage is
adequate and the 32kHz oscillator is running (RTC is on).
PWR_OFF In this mode (warm), the main battery is present and its voltage is over RETU master reset
threshold. All regulators are disabled, PurX is on low state, the RTC is on and the oscillator
is on. PWR_OFF (cold) mode is almost the same as PWR_OFF (warm), but the RTC and the
oscillator are off.
RESET RESET mode is a synonym for start-up sequence. In this mode certain regulators are
enabled and after they and RFClk have stabilized, the system reset (PurX) is released and
PWR_ON mode entered. RESET mode uses 32kHz clock to count the REST mode delay
(typically 16ms).
Page 9–10
Min Nom Max
-0.3
+3.
2
-0.3
0 2.5
Company Confidential
Copyright ©2005 Nokia. All Rights Reserved.
Unit Notes
+4.5 V Battery voltage maximum value is
specified during charging is active
+4.3 V Battery voltage maximum value is
specified during charging is active
+16V V
2.7 V Maximum capacity of the backup
power supply assumed to be 15 µAh.
RM-42
System Module
9241872 (Issue 1)