Tx Lo Leakage (Wcdma) - Nokia RM-42 Service Manual

Hide thumbs Also See for RM-42:
Table of Contents

Advertisement

Nokia Customer Care
4.
Click Start and OK.
5.
Adjust the "Mid Channel Power Level" to 21.0 dBm.
6.
Click Accept and OK.
7.
Read the marker power level on the low channel and fill it in to the "Low Power Level" line.
8.
Click Accept and OK.
9.
Read the marker power level on the high channel and fill it in to the "High Power Level" line.
10. Click Accept.
11. Check that the tuned values are within the limits presented in the following table. If they are OK, click Yes.
Tx Freq Comp (the first and last
value)
12. Close the tuning window.

Tx LO leakage (WCDMA)

Context
The purpose of Tx LO leakage tuning is to minimize the carrier leakage of the IQ-modulator which is caused by
the DC offset voltages in the Tx IQ-signal lines and in the actual IQ-modulator.
The tuning improves WCDMA Tx AGC dynamics at low power levels. A self-calibration routine selects the best
combination for internal control words in order to produce minimum LO leakage.
Steps
1. From the "Operating mode" dropdown menu, set mode to "Local" from Product/System Mode menu, choose
"WCDMA" to Selected System Mode and click Write. NOTE! After tuning is done change system mode back to
Dual by choosing "Free" to Selected System Mode and click Write.
Page 7–54
Min
-4
Company Confidential
Copyright ©2005 Nokia. All Rights Reserved.
RF Troubleshooting and Manual Tuning Guide
Max
+4
RM-42
9241872 (Issue 1)

Advertisement

Table of Contents
loading

Table of Contents