Nokia RM-42 Service Manual page 296

Nokia Customer Care
help go to the next step.
3.1.1.1.3.1.3.3 Replace Vinku (N7501) or Hinku (N7500) or both
3.1.1.1.3.1.4 Replace Vinku (N7501)
3.1.1.1.3.2 Are capacitors in Vinku (N7501) regulator lines working correctly?
VREG1: C7543
VREG2: C7547, C7548, C7554, C7555, C7553, C7552, C7558 and C7567
• Check that components are in place and solder joints are ok
• Disconnect the power supply from the phone and use an ohmmeter to check that regulator lines
are not short-circuited to the ground. If short-circuit is found replace capacitors mentioned above.
If this does not help go to the next step.
3.1.1.1.3.3 TX VCO (G7502) ok?
3.1.1.1.3.4 Replace Vinku (N7501)
3.1.1.1.4 VXO-voltage ok? (=Vdig).
• Measurement can be done with an oscilloscope and a probe
• Connect the probe to C7560 (or C7526, C7513)
• VXO-voltage should be about 2.5 V
3.1.1.1.4.1 C7560, C7513, C7526 and C2214 ok?
• Check that components are in place and solder joints are ok
• Disconnect the power supply from the phone and use an ohmmeter to find out if the VXO-line is
short-circuited to the ground. If short-circuit is found replace C7560, C7513, C7526 and C2214. If
replacing does not help then go to the next steps.
3.1.1.1.4.2 Replace Retu
3.1.1.1.4.3 Replace Hinku (N7500) or Vinku (N7501) or VCTCXO (G7501) or all three components
3.1.1.1.5 VCP2-voltage ok?
• GSM transmitter has to be active before VCP2 voltage can be measured. Procedure is explained in
section "Transmitter troubleshooting".
• Measurement can be done with an oscilloscope and a probe.
• Connect the probe to C2221 (or C7550).
• VCP2 voltage should be about 4.75 V.
A-28
Company Confidential
Copyright © 2005 Nokia. All rights reserved
Appendix A: RF Troubleshooting