Stihl MS 192 T Instruction Manual page 33

Models with ElastoStart
Pry the cap out of the starter grip.
N
Remove the remaining rope from
N
the rotor and grip.
Thread the new rope through the
N
starter grip and tie a simple
overhand knot.
Pull the knot back into the grip.
N
Refit the cap in the starter grip.
N
MS 192 T, MS 192 TC
5
Thread the rope through the top of
N
the guide bushing (5).
Thread the rope through the rotor
N
and secure it with a simple
overhand knot.
2
3
4
Coat rope rotor bearing bore with
N
non-resinous oil.
Slip the rotor over the starter post –
N
turn it back and forth to engage the
anchor loop of the rewind spring.
Fit the pawl (4) in the rotor and fit
N
the washer (3) on the starter post.
Use a screwdriver or suitable pliers
N
to install the spring clip (2) on the
starter post and engage it on the
pawl's peg – the spring clip must
point clockwise as shown in the
illustration.
Tensioning the rewind spring
Make a loop in the unwound starter
N
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
Hold the rotor steady.
N
Pull out and straighten the twisted
N
rope.
Let go of the rotor.
N
Release the rope slowly so that it
N
winds onto the rotor.
The starter grip must locate firmly in the
rope bushing. If the grip droops to one
side: Add one more turn on the rope
rotor to increase spring tension.
When the starter rope is fully extended it
must still be possible to rotate the rotor
another half turn. If this is not the case,
the spring is overtensioned and could
break.
English
31