Stihl MS 192 T Instruction Manual page 23

If the engine is cold
Move the choke lever (5) to l.
N
If the engine is warm
Set the choke lever (5) to j . Also
N
use this position if the engine has
been running but is still cold.
MS 192 T, MS 192 TC
Place your saw on the ground.
N
Make sure you have a firm footing –
check that the chain is not touching
any object or the ground.
WARNING
Bystanders must be well clear of the
general work area of the saw.
Hold the saw firmly on the ground
N
with your right hand on the control
handle and your right knee resting
on the carburetor box cover.
Models with stardard starter
Pull the starter grip slowly with your
N
left hand until you feel it engage –
and then give it a brisk strong pull
and push down the front handle at
the same time. Do not pull out the
starter rope to full length – it might
otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Models with ErgoStart
The ErgoStart stores the energy
required to start the saw. For this reason
there may be a delay of a few seconds
between cranking the engine and it
actually starting.
Pull the starter grip slowly and
N
steadily with your left hand and push
down the front handle at the same
English
21