Automatic Switch-Off; Cleaning System; Before Cleaning; Setting The Cleaning Level - Siemens HB36GB.60 Instruction Manual

Press the button repeatedly until the required basic setting
±
2.
appears.
Use the rotary selector to change the value of the basic
3.
setting.

Automatic switch-off

Your oven has an automatic switch-off function. It is activated if
no cooking time is set and the settings have not been changed
for a long time. The point at which this occurs depends on the
temperature or grill setting that has been set.
Switch-off activated
"‰ appears in the display. Operation is interrupted.

Cleaning system

The cleaning system regenerates the self-cleaning surfaces in
the cooking compartment.
The self-cleaning surfaces are coated with a highly porous
ceramic layer. This coating absorbs and disintegrates splashes
from baking and roasting while the oven is in operation. If the
surfaces no longer clean sufficiently and dark stains appear,
they can be regenerated with the cleaning system.
Retrofitting the self-cleaning ceiling and side walls
The back wall in the cooking compartment is coated with
ceramic. In order for you to be able to use the cleaning system,
the ceiling and side walls must also be coated. You can obtain
the self-cleaning ceiling and side walls as a special accessory
from the after-sales service.
Changing the basic settings
When you have retrofitted the self-cleaning ceiling and side
walls, you must activate the cleaning system in the basic
settings. To find out how to do this, refer to the Basic settings
section.
Cleaning levels
You can choose from three cleaning levels.
Level Degree of cleaning
1 gentle
2 moderate
3 intensive
Duration
approx. 45 minutes
approx. 1 hour
approx. 1 hour, 15 minutes
You can now change other basic settings, as described in
4.
points 2 and 3.
Press and hold the button until the display disappears. This
±
5.
takes about four seconds. All changes are saved.
Cancelling
Press the button. The changes are not applied.
‡
Press any button to make the display message go out. You can
make new settings.
Note: If a cooking time is set, the oven stops heating once the
cooking time has elapsed. The automatic switch-off function is
not necessary.

Before cleaning

Remove accessories and cookware from the cooking
compartment.
Cleaning the cooking compartment floor
Before you set the cleaning system, clean the surfaces in the
cooking compartment that are not self-cleaning. Otherwise,
stains will develop that it is not possible to remove.
Use a dish cloth and hot soapy water or a vinegar solution. If
there are heavy deposits of dirt, use a stainless steel scouring
pad or oven cleaner. Only use when the cooking compartment
is cold. Never treat the self-cleaning surfaces with a scouring
pad or oven cleaner.

Setting the cleaning level

Press the button.
s
1.
Cleaning level 3 is suggested.
If you wish to change the cleaning level:
Select the desired cleaning level using the rotary selector.
2.
Start the cleaning operation with
3.
Once cleaning has finished
‹ : ‹‹ appears in the display. The oven stops heating.
Cancelling cleaning
Press and hold the † button until
appears. You can make new settings.
Adjusting the cleaning level
Once cleaning starts, the cleaning level can no longer be
changed.
† .
: 3D hot air, 160 °C
15