Operation - Panasonic AJ-HD1200A Operating Instructions Manual

Setup menus

OPERATION

Item
Superimposed
No. No.
display
101 SHTL MAX
0000
0001
0002
102 FF.REW MAX
0000
0001
0002
104 REF ALARM
0000
0001
106 EJECT EE SEL
0000
0001
0002
107 EE MODE SEL
0000
0001
108 PLAY DELAY 0000
0015
109 CAP LOCK
0000
0001
0002
2 This appears when the AJ-YA120AG (optional accessory) or AJ-YAD120AG (optional accessory) has been
installed.
" " indicates the factory setting.
Setting
Superimposed
display
For setting the maximum speed in the shuttle mode when using the external
controller connected to the 9-pin remote connector.
X8.4 0: 8.4k normal speed
X16 1: 16k normal speed
X32 2: 32k normal speed
<Note>
The maximum speed for the HD SP mode is automatically limited to 25k normal
speed.
For setting the maximum speed of fast forward or rewind operations.
X16 0: 16k normal speed
X32 1: 32k normal speed
X50 2: 50k normal speed
<Notes>
O The maximum speed for the DV and DVCAM modes is automatically limited to
32k normal speed.
O The maximum speed for the HD SP mode is automatically limited to 25k normal
speed.
For setting whether a warning is to be displayed when the REF VIDEO signal is not
connected.
OFF 0: No warning is displayed.
ON 1: A warning is displayed by the flashing STOP lamp.
For setting the video and audio output statuses during eject.
EE 0: Both the video and audio signals are always output in the E-E (electric
modulation to electric playback) mode regardless of the position of the TAPE/EE
switch.
BLACK 1: The output status differs according to the position of the TAPE/EE switch.
EE:
TAPE: BLACK is output for the video, and the audio is muted.
GRAY 2: The output status differs according to the position of the TAPE/EE switch.
EE:
TAPE: GRAY is output for the video, and the audio is muted.
<Note>
The EE pictures will be all black when the AJ-YA120AG (optional accessory) or AJ-
YAD120AG (optional accessory) is not installed.
For selecting the output signals in the EE mode.
NORMAL 0: Signals delayed by the time taken by internal signal processing are output.
THRU 1: Signal processing is not undertaken internally, and the signals are output
without delay at their original timing.
<Note>
The superimposed information is not displayed when THRU is used as the setting.
0 For setting the play rise time in frame increments.
: :
15
For selecting in how many field increments the playback framing is to be locked.
2F 0: 2F
4F 1: 4F
8F 2: 8F
<Notes>
O 8F can be selected only when 50 is selected as the menu item No.25 [SYSTEM
FREQ] setting.
O In the HD LP or HD SP mode, the 2F mode is selected during recording
including follow-on recording, and playback regardless of the menu item's
setting.
Description of settings
The signals are output in the E-E mode.
The signals are output in the E-E mode.
,
2
37