Setting The User's Bit; Playing Back The Time Code And User's Bit - Panasonic AJ-HD1200A Operating Instructions Manual

Time code & user's bit

Setting the user's bit

This function can be used only when the AJ-YA120AG
(optional accessory) or AJ-YAD120AG (optional
accessory) is installed.
1
Set the VTR to the menu mode.
(This is done by setting the LOCAL/MENU/
REMOTE switch to the MENU position).
2
Select menu item No.531 [UB PRESET].
The following steps are the same as for setting
the time code.
Playing back the time code and
user's bit
1
Set the unit to the STOP mode.
2
Set the COUNTER button to TC or UB.
TC : The time code is displayed.
UB : The user's bit is displayed.
3
Press the PLAY button.
Playback commences, and the time code
appears on the display.
When CMPST has been selected as the menu
item No.005 [SUPER] setting, the time code
value is superimposed onto the video signals
which are output from the VIDEO OUT2
connector.
<Notes>
O When a drop frame time code is read, the colon
between the seconds and frames is replaced with a
period.
O When the time code signal is temporarily missing, it
is automatically filled in by the CTL signal.
Below are displayed.
Superimposed display
T R 00 : 07 : 04 : 24
2
An asterisk 2 appears here when
the time code signal is temporarily
missing.
In the case of a drop frame, a period (.)
appears in place of the colon between the
seconds and frames.
Counter display
TC 00 : 07 : 04 : 24
UB
This flashes when the time code
signal is temporarily missing.
In the case of a drop frame, a period (.)
appears in place of the colon between the
seconds and frames.
21