Panasonic AJ-HD1200A Operating Instructions Manual page 47

Setup menus
AUDIO
Item
Superimposed
No. No.
display
730 REC CUE
0001
0002
0003
0004
0005
0006
0007
0008
0009
0010
0011
0012
0013
731 PB FADE
0000
0001
0002
732 EMBEDDED AUD
0000
0001
759 DV PB ATT
0000
0001
760 REC PT MUTE
0000
0001
762 AUD RATE CON
0000
0001
765 CUE OUT SEL
0000
0001
769 MONI SEL
0000
0001
" " indicates the factory setting.
Setting
Superimposed
display
For setting the input signal to be recorded on the CUE track.
CH1 1: Audio input CH1 signal
CH2 2: Audio input CH2 signal
CH3 3: Audio input CH3 signal
CH4 4: Audio input CH4 signal
CH5 5: Audio input CH5 signal
CH6 6: Audio input CH6 signal
CH7 7: Audio input CH7 signal
CH8 8: Audio input CH8 signal
CH1+2 9: Audio input CH1 + CH2 mixed signal
CH3+4 10: Audio input CH3 + CH4 mixed signal
CH5+6 11: Audio input CH5 + CH6 mixed signal
CH7+8 12: Audio input CH7 + CH8 mixed signal
CH1~8 13: Audio input CH1 through CH8 mixed signal
For setting the processing for the audio edit points (IN point, OUT point) and follow-
on recording point during playback.
AUTO 0: The processing follows the status established during recording.
CUT 1: Cut processing is forcibly performed.
FADE 2: Fade processing is forcibly performed.
For setting whether to superimpose audio data onto the HD SDI output and SD SDI
output.
OFF 0: The audio data is not superimposed.
ON 1: The audio data is superimposed.
For selecting the audio output level during DV format playback.
OFF 0: The audio output level is not attenuated.
ON 1: The audio output level is attenuated.
For selecting whether to mute the sound at the joins in the recording during DV or
DVCAM format playback.
OFF 0: The sound is not muted.
ON 1: The sound is muted.
For setting whether the tape is to be played back without passing the signals
through the rate converter (without activating the digital filter) in the digital audio
output unit.
OFF 0: The tape is played back without passing the signals through the rate converter.
ON 1: The signals are passed through the rate converter, and the tape is played back.
<Notes>
O In modes other than the 60 Hz mode, the signals are not passed through the
rate converter regardless of this menu item's setting.
O ON/OFF control is exercised for channels 1 through 8 at the same time.
Separate settings cannot be performed on a channel by channel basis.
For setting whether to output the analog CUE signal to the audio output (main line).
OFF 0: The analog CUE signal is not output.
During playback, PCM sound is output; in all other modes, no sound is output.
ON 1: The analog CUE signal is output.
During playback, PCM sound is output; in all other modes, the analog CUE
signal is output.
For setting the monitor output sound during playback.
PLY PCM 0: PCM sound is output.
PLY CUE 1: CUE sound is output.
Description of settings
47