Panasonic AJ-HD1200A Operating Instructions Manual page 42

Setup menus
TIME CODE
Item
Superimposed
No. No.
display
508 BINARY GP
0000
0001
0002
0003
0004
0005
0006
0007
509 PHASE CORR
0000
0001
510 TCG CF FLAG
0000
0001
511 DF MODE
0000
0001
512 TC OUT REF
0000
0001
513 VITC OUT
0000
0001
514 HD EMBD VITC
0000
0001
515 HD EMBD LTC
0000
0001
530 TC PRESET
531 UB PRESET
" " indicates the factory setting.
42
Setting
Superimposed
display
For setting the usage status for the user's bit of the time code generated by the
TCG.
000 0: No character set specified
001 1: 8-bit character set complying with the ISO646 and ISO2022 standards
010 2: Undefined
011 3: Undefined
100 4: Undefined
101 5: Page/line
110 6: Undefined
111 7: Undefined
For setting whether to control the phase correction of the LTC output during
playback.
OFF 0: The phase correction is not controlled.
ON 1: The phase correction is controlled.
For selecting whether to set the CF flag of the TCG to ON.
OFF 0: The CF flag is set to OFF.
ON 1: The CF flag is set to ON.
For selecting whether to use the DF or NDF mode for CTL and TCG.
DF 0: The drop frame (DF) mode is used.
NDF 1: The non-drop frame (NDF) mode is used.
For setting the signal to be used as the reference for aligning the phase of the time
code which is output from the TC OUT connector with the phase of the external TC
input signal when a setting other than INT is selected as the menu item No.507 [TC
SOURCE] setting. (In EE mode only)
VOUT 0: The output video signal is used as the reference.
TC_IN 1: The external time code input signal is used as the reference.
For selecting how to output the VITC signal which is superimposed onto the output
video signal.
SBC 0: In the playback mode, the time code recorded in the SBC area is output.
VAUX 1: In the playback mode, the time code recorded in the VAUX area is output.
<Note>
O The VITC information which is detected by the HD serial input is automatically
recorded in the VAUX area when the images are recorded.
O When "23/24," "25(HD)" or "25(SD)" is selected as the menu item No.25
[SYSTEM FREQ] setting and VAUX is selected as the VITC OUT setting, the
time code which is output may not be continuous.
For selecting whether to superimpose the VITC information onto the HD serial
output.
OFF 0: The VITC information is not superimposed.
ON 1: The VITC information is superimposed.
For selecting whether to superimpose the LTC information onto the HD serial
output.
OFF 0: The LTC information is not superimposed.
ON 1: The LTC information is superimposed.
For setting the time code of the internal TCG.
00000000 to 23595929
Selection range of 00000000 to 23595924 when 50i/25P is selected as the menu
item No.35 [SYSTEM FREQ] setting
For setting the user's bit of the internal TCG.
00000000 to FFFFFFFF
Description of settings