Setting The Time Code; Setting The User's Bit - Panasonic AJ-D250P Operating Instructions Manual

Time Codes and User's Bit

Setting the time code

1
Set the unit to the menu mode (by setting the LOCAL/MENU/REMOTE switch to the
MENU position).
2
Select the "TC PRESET" setup menu item, and press the DATA+ button
(PAUSE/STILL button) or DATA– button (PLAY button).
(See page 32)
3
Select the digit to be changed (blinking display) using the UP button (FF button) or
DOWN button (STOP button).
4
The value is incremented or decremented using the DATA+ button (PAUSE/STILL
button) or DATA– button (PLAY button).
5
Press the SET button (REC button) upon completion of the settings.
6
Set the LOCAL/MENU/REMOTE switch to the LOCAL or REMOTE position.
<Notes>
O The current time code value appears as the default value.
O When the RESET button is pressed while the digit to be changed is blinking, the display is
reset to "00:00:00:00."
O The time code cannot be set unless P-REC or P-FREE has been selected as the "TC MODE"
setup menu item setting. (See page 32)
O If the MODE button (REW button) is pressed instead of the SET button while the digit to be
changed is blinking, the time code setting will be canceled.

Setting the user's bit

1
Set the unit to the menu mode (by setting the LOCAL/MENU/REMOTE switch to the
MENU position).
2
Select the UB PRESET setup menu item, and press the DATA+ button
(PAUSE/STILL button) or DATA– button (PLAY button).
(See page 32)
Now follow the same procedure as for setting the time code.
19