Errors And Remedial Measures - Ribao JM-90 Instruction Manual

8. ERRORS AND REMEDIAL MEASURES

When an error occurs during counting, the LCD Display will flash the error code. Clear the error
in accordance with the following procedures.
Error
Code
Hopper Sensor is covered.
EA
1, One or both of Counting Sensors
are damaged if E1 appears when
E1 power on.
2, Counting Sensors are dirty.
3, Notes are jammed in the roller.
1, Notes on Stacker when power
on.
E2
2, Stacker Sensor is dirty.
3, Stacker Sensor is damaged.
1, Hopper Sensor is covered when
power on.
E3
2, Hopper Sensor is dirty.
3, Hopper Sensor is damaged.
1, Half-sized note is fed.
2, A small note passes from the left
or right side.
EH
3, One of Counting Sensors is
damaged.
More than two notes are fed in
Ec
chain.
Two notes are fed at a time or a
Ed
dirty note is fed.
Suspected
CF1
detected by UV detection.
Suspected
CF2
detected by MG detection.
Cause of Error
counterfeit note
counterfeit note
Remove what is covering the Hopper Sensor.
1, Replace the damaged Counting Sensor.
2, Clean the Counting Sensors. (Refer to Chapter 7)
3, Take away jammed note(s) with hand. When there is a
difficulty in taking away the jammed notes, turn Drum
Rollers by hand.
1, Remove the notes placed on the Stacker.
2, Clean the Stacker Sensor with the brush. (Refer to Chapter 7)
3, Replace the damaged Stacker Sensor.
1, Remove what is covering the Hopper Sensor.
2, Clean the Hopper Sensor with the brush. (Refer to Chapter 7)
3, Replace the damaged Hopper Sensor.
1, Take away the half-sized note.
2, Let the note pass in the middle.
3, Replace the damaged Counting Sensor.
If this error happens very often, the Feed Gap might be too wide.
Adjust the size of the gap. (Refer to Chapter 6)
If this error happens very often, adjust the DEN Function. (Refer
to Chapter 6 of the Service Manual)
1, Take away the last note from the Stacker and make sure that it
is
is the same note as the others.
2, Press RESTART key.
3, Recount the last note taken away from the Stacker.
1, Take away the last note from the Stacker and make sure that it
is
is the same note as the others.
2, Press RESTART key.
3, Recount the last note taken away from the Stacker.
Remedial Measures
14