HP rp5800 Reference Manual page 58

12. Align the guide screws with the slots on the chassis drive cage, press the hard drive down into
the bay, then slide it back until it stops and locks in place.
Figure 2-63
13. Connect the power cable (1) and data cable (2) to the back of the hard drive.
NOTE:
labeled SATA0 on the system board to avoid any hard drive performance problems.
Figure 2-64
NOTE:
board drive connectors.
14. Rotate the drive cage for internal drives and the power supply down to their normal positions.
15. Replace the access panel.
16. If the computer was on a stand, replace the stand.
17. Reconnect the power cord and any external devices, then turn on the computer.
18. Lock any security devices that were disengaged when the access panel was removed.
52 Chapter 2 Hardware Upgrades
Installing the Hard Drive
The data cable for the primary hard drive must be connected to the dark blue connector
Connecting the Hard Drive Power and Data Cables
Refer to System Board Drive Connections on page 40 for an illustration of the system
ENWW