HP rp5800 Reference Manual page 50

8. Install four M3 metric guide screws in the lower holes on each side of the drive. HP has provided
four extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3
metric guide screws are black. Refer to
illustration of the extra M3 metric guide screws location.
NOTE:
the new one.
CAUTION:
internal components of the drive.
Figure 2-48
9. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive
toward the front of the computer until it locks into place.
Figure 2-49
44 Chapter 2 Hardware Upgrades
When replacing the drive, transfer the four M3 metric guide screws from the old drive to
Use only 5-mm long screws as guide screws. Longer screws can damage the
Installing Guide Screws in the Optical Drive
Installing the Optical Drive
Installing and Removing Drives on page 38 for an
ENWW