HP rp5800 Reference Manual page 41

14. To install the new riser card, press the riser card firmly down into the riser card slot on the
system board (1) and plug the hood sensor cable into the hood sensor connector on the system
board (2).
Figure 2-36
15. If any expansion cards were removed from the old riser card, install the cards into the
appropriate slots on the new riser card. Move the card toward the rear of the chassis so that the
bracket on the card is aligned with the open slot on the rear of the chassis (1). Press the card
straight down into the expansion socket on the riser card (2).
Figure 2-37
ENWW
Installing the Riser Card
Installing an Expansion Card in the Riser Card
Replacing the Riser Card 35