10.
Rotate the drive cage to its upright position.
Figure 2-50
11.
Connect the power cable (1) and data cable (2) to the rear of the optical drive.
NOTE:
system board to the primary hard drive, then to the secondary hard drive, then to the rear of the
optical drive.
Figure 2-51
12.
Connect the SATA data cable to the black eSATA connector on the system board labeled
SATA2 unless an eSATA adapter is installed. If an eSATA adapter is installed, connect the
SATA data cable to the light blue SATA connector on the system board labeled SATA1.
NOTE:
board drive connectors.
ENWW
Rotating the Drive Cage Up
The power cable for the optical drive is a three-headed cable that is routed from the
Connecting the Power and Data Cables
Refer to
System Board Drive Connections on page 40
for an illustration of the system
Installing and Removing Drives
45