Installing A 5.25-Inch Optical Drive Into A Drive Bay - HP rp5800 Reference Manual

10. Press down on the green drive retainer button located on the left side of the drive to disengage
the drive from the drive cage (1). While pressing the drive retainer button, slide the drive back
until it stops, then lift it up and out of the drive cage (2).
Figure 2-47

Installing a 5.25-inch Optical Drive into a Drive Bay

1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as compact discs or USB flash drives, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
5. If the computer is on a stand, remove the computer from the stand.
6. Remove the computer access panel.
7. On some models, you may need to replace the driveless section of the front bezel with an optical
drive bezel. On other models, you may need to remove a bezel blank from the optical drive
bezel.
●
If you are replacing the driveless bezel with an optical drive bezel, remove the front bezel
and install the optical drive bezel. See
information
●
If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then
remove the bezel blank. See
ENWW
Removing the 5.25-inch Drive
Regardless of the power-on state, voltage is always present on the system board
Removing a Bezel Blank on page 11
Installing an Optical Drive Bezel on page 10
Installing and Removing Drives
for more
for more information.
43