Teac PL-D1800 Owner's Manual page 25

Automatic tuning
1. Press TUNER to select tuner mode.
2. After two seconds the display will change to show the current band and frequency.
3. If necessary, press TUNER again to switch between MW and FM band.
4. Press and hold
station is reached, auto tuning will stop.
Note: Press "Pause" button on the Front Panel can toggle between the frequency tune up & down and preset
channel up & down.
Tuning to a weak FM stations
1. Press
2. Press FM MODE on the remote control to switch to Mono mode. This will reduce the background noise
and make the station easier to listen.
Preset Stations
When a preset station is selected, the preset number will appear next to the frequency on the display.
Selecting Preset Stations
1. In tuner mode, press TUNER to switch between MW and FM band if necessary.
2. Press OK, then use
desired preset station.
Storing Preset Stations
The unit can store up to 20 stations in the FM and MW wavebands respectively.
1. In tuner mode, press TUNER to switch between MW and FM band.
2. Press
3. Press and hold OK until the preset channel icon flashes.
4. Press
GB 22
or for more than one second to activate auto tuning mode. When a
to tune in a weak FM station manually.
MHz
MHz
MHz
/ on the Front Panel or the remote's numeric keys or
MHz
to tune in the desired station.
M Hz
or use the remote's numeric keys to select the preset channel number .
to select