Sound - Teac PL-D1800 Owner's Manual

Incorrect setting of this item can corrupt the picture. If the
picture becomes distorted or unusable after proceeding this
step, wait a few seconds and the settings will be restored to its
p revious value.
Press "OK" to continue.
No, switch to Component output.
Yes, switch to Progressive Scan output.
Does your TV support Progressive Scan mode?
And have you connected the Component Video Output
Cable to your TV and your TV has set up accordingly?
No
Yes
Component
SCART

SOUND

OFF
ON
Speaker Setup
Three options are available to adjust your speakers setting to
best fit your listening environment.
Speakers
You can indicate the presence and size of speakers you have
connected to your system within this menu. Options available are
as below. Press OK to confirm your selections.
GB 16
Progressive Scan
By displaying all the lines of a picture simultaneous (instead of displaying odd
and even lines alternatively such as a conventional TV), Progressive Scan greatly
enhances picture resolution while minimizing distortion and flickering. To use
this feature, your TV must be Progressive Scan compatible with
Component Video input jacks connected to the DVD unit.
1. Set your unit to PAL output mode.
2. Select the Progressive Scan option and press OK (or V.Select on the
remote control) to activate.
3. A caution message will display. Press OK to continue.
Caution: If you see distorted or no picture after pressed OK, then check the
following:
i) Your TV may not be Progressive Scan compatible. Wait a few seconds
and the unit will have return to the previous setting before change.
ii) Make sure your TV is connected with Component Video output from the
DVD unit and is now switched to view such input through which Progressive
Scan signals are transmitted . There will be no video signal from AV output,
in case you have both Component Video and AV connections.
4. A message requesting for confirmation will appear on screen. Select Yes
(confirm) or No (return to previous setting) by
and press OK to confirm.
Video Output
Press OK to select between Component Output and SCART Output to match
the video output of your DVD unit.
DRC
Press OK to turn on/off. This controls the Dynamic Range Compression
(DRC) for night time listening. DRC reduces the difference between normal
voices and sounds such as like explosion to avoid waking your neighbours.
The amount of range control available depends on the disc.
Digital Output
Press OK to check the box if you have connected the unit's digital audio
output to a receiver with Dolby Digital or DTS.
DRC
Digital Output
Speaker Setup
Sound PL II Mode
PL II Control
Music