PhaseOne P 65+ User Manual page 18

•
•
Indicator lights
Upon powering up the P+ back the green and red LED's on the right
will flash shortly and you will hear a beep, which indicates that the P+
back is ready to capture. In general, if the LEDs are not illuminated the
camera is ready.
Green LED
When capturing an image the green LED is flashing rapidly to indicate
that the P+ back is busy exposing the CCD or moving data from the
CCD.
A steady green light indicates that the backlight of the LCD display
is dimmed but that the camera is still ready to shoot. The timing of
when the LCD backlight is dimmed can be set in the P+ back and is
described later under "Menu mode"
Red LED
The red LED indicates that the P 65+ back holds data not yet saved on
the CF card or if tethered session, on the computer.
The red LED indicator located just beside the CF-cardslot under the
cover on the left hand side indicates that P 65+ is handling data to or
from the CF card.
NB! When the red light is on please do not remove the card from the card
slot! This will damage the formatting of the card, resulting in corrupted
data or lost images.
IR filter on the CCD
The IR filter (Infrared reduction filter) is permanently mounted on top of
the CCD.
• The filter may not be removed for several reasons:
• The focusing of the P+ back camera back will be damaged.
• It is only possible to remount the filter without dust in between the
filter and the CCD if you have access to special clean room facilities.
• The Phase One Product Warranty is terminated.
18