Table of Contents
Advertisement
[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-menu.
Refer to "Navigating through the menu" ( x page 48) for the operation of the menu screen.
[STATUS]
Display the status of the projector.
Press as to select [STATUS].
1)
2)
Press the <ENTER> button.
f The [STATUS] screen is displayed.
[SIGNAL]
1
[RUNTIME]
*
[SERIAL NUMBER]
*1 The following conversion is required to calculate the rough estimate for lamp replacement.
A × 1 + B × 4/5
f A : Runtime which is displayed in [STATUS] screen → [RUNTIME] → [LAMP] → [NORMAL]
f B : Runtime which is displayed in [STATUS] screen → [RUNTIME] → [LAMP] → [ECO]
Note
f The "RUNTIME" displayed in the [STATUS] may be different from the actual times when a lamp unit that was attached to a different projector
model is installed on this projector, or when the lamp unit that was attached to this projector is installed on a different projector model.
f The [SIGNAL] is shown in gray and the values are blank for [NETWORK] input.
[COMPUTER INPUT SETTING]
Set the computer input signal.
Press as to select [COMPUTER INPUT SETTING].
1)
Press qw to switch the item.
2)
f The items will switch each time you press the button.
[RGB/YP
P
]
B
R
[Y/C]
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
Press as to select [PROJECTOR ID].
1)
2)
Press the <ENTER> button.
f The [PROJECTOR ID] screen is displayed.
Press as to switch the item.
3)
f The items will switch each time you press the button.
[ALL]
[1] ~ [6]
4)
Press the <ENTER> button.
70 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
[NAME]
[FREQUENCY]
[PROJECTOR]
[ECO]
[LAMP]
[NORMAL]
[TOTAL]
[PROJECTOR]
Formula for lamp replacement time (rough estimate)
Set the computer input signal to RGB/YP
Set the computer input signal to Y/C.
Select this item to control projectors without specifying an ID number.
Select this item when specifying an ID number to control individual projector.
Displays the name of input signal.
Displays the scanning frequency of input signal.
Displays the current usage time of projector.
Displays the lamp runtime when [LAMP POWER] is set to [ECO] by
actual time.
Displays the lamp runtime when [LAMP POWER] is set to [NORMAL] by
actual time.
Displays the total runtime of the lamp.
Displays the serial number of the projector.
P
.
B
R
Advertisement
Table of Contents
