Setting The Id Number Of The Remote Control - Panasonic PT-SW280A Operating Instructions Manual

Chapter 3 Basic Operations — Operating with the remote control

Setting the ID number of the remote control

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually by using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID ALL>
button on the remote control. Also, you can control a projector by pressing the <ID ALL> button on the remote
control even if you do not know the projector ID.
buttons
1)
Press the <ID SET> button.
2)
Within five seconds, press and set the one-digit or two-digit ID number set on the projector using the number
(<1> - <6>) buttons.
f If you press the <ID ALL> button, you can control the projectors regardless of the ID number setting of the
projector.
Attention
f Since the ID number of the remote control can be set without the projector, do not press the <ID ALL> button on the remote control
carelessly. If the <ID SET> button is pressed and no number (<1> - <6>) buttons are pressed within five seconds, the ID number returns to
its original value before the <ID SET> button was pressed.
f The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control is left with dead
batteries. Set the same ID number again when the batteries are replaced.
Note
f Set the ID number of the projector from the [PROJECTOR SETUP] menu → [PROJECTOR ID]. ( x page 70)
46 - ENGLISH