Table of Contents
Advertisement
8)
Press the <MENU> button on the remote control or the control panel.
f The main menu screen appears.
Press as to select [PROJECTOR SETUP] and press the <ENTER> button.
9)
f The [PROJECTOR SETUP] screen is displayed.
10) Press as to select [LAMP RUNTIME]
11) Press and hold the <ENTER> button for approximately 3 seconds.
f The [
LAMP RUNTIME RESET
LAMP RUNTIME
ENTER
SELECT
12) Press qw to select [OK] and press the <ENTER> button.
13) Press the power < v / b > button.
14) After the lamp goes off, projection stops and the <ON(G) / Standby(R)> indicator lit red. Disconnect the power
plug. The lamp runtime has been reset to "0".
Note
f If any button other than the Power < v / b > button is pressed, the LAMP RUNTIME screen disappears and the lamp runtime is not reset. (Repeat
from step 8 again).
106 - ENGLISH
Chapter 6 Maintenance — Care and Replacement (continued)
.
] screen is displayed.
LAMP RUNTIME RESET
OK
CANCEL
RETURN
Advertisement
Table of Contents
