Cadillac ATS 2017 Owner's Manual page 338

position it is in. Directional tires
will have an arrow on the tire
indicating the proper direction of
rotation or will have left or
right molded on the sidewall.
Use this rotation pattern if the
vehicle has different size tires on
the front and rear and they are
non-directional.
Different tire sizes should not be
rotated front to rear.
Use this rotation pattern when
rotating tires of the same size
installed on all four wheel
positions.
If the vehicle has a compact spare
tire, do not include it in the tire
rotation.
Adjust the front and rear tires to
the recommended inflation
pressure on the Tire and Loading
Information label after the tires
have been rotated. See Tire
Pressure 0 330 and Vehicle Load
Limits 0 218.
VEHICLE CARE
Reset the Tire Pressure Monitor
System. See Tire Pressure Monitor
Operation 0 333.
Check that all wheel nuts are
properly tightened. See Wheel
Nut Torque under Capacities and
Specifications 0 382.
Warning
Rust or dirt on a wheel, or on the
parts to which it is fastened, can
make wheel nuts become loose
after time. The wheel could come
off and cause an accident. When
changing a wheel, remove any rust
or dirt from places where the wheel
attaches to the vehicle. In an
emergency, a cloth or a paper towel
can be used; however, use a scraper
or wire brush later to remove all
rust or dirt.
Lightly coat the center of the
wheel hub with wheel bearing
grease after a wheel change or tire
rotation to prevent corrosion or
rust build-up. Do not get grease
337