Whirlpool AMD 385 Instructions For Use Manual page 20

4. Fix the air filters
5. Reset of the filter indication
Press " Emergency switch " button. The FILTER indication with disappear and the next filter cleaning time
will be set.
Note: It is necessary to clean the air filter after using it for about 100 hours. If forgeting to set the cleaning
period of filter, clean the air filter every two weeks if the air conditioner operates in an extremely dusty
environment.
HOW TO CLEAN THE SUCTION GRILLE
1. Open the suction grille (See step 1 of "Take out the filter").
2. Remove the air filters (See step 2 of "Take out the filter").
3. Remove the suction grille.
4. Wash with water.
When the suction grille is very dirty, use soft brush and neutral detergent. Shake off water and dry in a
shady place.
Note: Do not wash with hot water.
5. Fix the suction grille (Refer to step 2).
6. Fix the air filter (See step 4 "How to clean the air filter").
7. Close the suction grille (Refer to step 1).
BEFORE STARTING THE AIR CONDITIONER FOR THE FIRST TIME IN THE SEASON
1. Check to make sure no object obstructing the intake and outlets parts on both the indoor and outdoor
units.
2. Check to make sure ground wire is connected and not damaged.
3. Check to make sure air filter has been cleaned.
4. Turn on the power 6 hour before starting the air conditioner.
END OF SEASON CLEANING
1. Clean the filter and the body of the unit.
2. Turn off power.
3. Clean outdoor unit from dust.
4. If there is any rust in the outdoor unit, this should be
painted over to prevent the rust from spreading.
21
Shut off
power