Closing The Chassis Cover - Cisco AS5200-PWR-AC Replacement Manual

Step 6
Figure 13

Closing the Chassis Cover

Refer to Figure 14 and take these steps:
Step 1
Step 2
If you installed a different type of power supply (AC or DC) than was originally installed
in the access server, place one of the power ratings labels that came in the plastic bag with
the documentation directly over the power ratings information on the rear panel. For
example, if the original chassis came with an AC power supply and you replaced it with
a DC power supply, place the DC power ratings label over the ratings stamped on the rear
panel of the chassis. This will ensure that the correct power ratings information appears
on the rear panel.
Attaching the Power Ratings Label
INPUT 100-240V
Label
Place the chassis bottom so that the front panel is facing you.
Hold the top cover over the chassis bottom, and align the chassis and top cover tabs at the
top rear of the chassis.
Replacing the Power Supply in Cisco AS5200 Universal Access Servers
~
50/60HZ 1.5 - 3.0A
Closing the Chassis Cover
13