Cisco AS5200-PWR-AC Replacement Manual page 8

Removing the Power Supply
Step 4
Figure 6
Step 5
8 Replacing the Power Supply in Cisco AS5200 Universal Access Servers
Locate the two small two-pin connectors that power the fans. Grasp the two halves of
each connector firmly and pull them apart. If the tie-wraps get in your way, cut them. But
be careful not to cut the wires. If the wires are cut, the fans will not operate.
Disconnecting the Two-Pin Connectors
Locate the large rectangular 11-pin connector that connects the power supply to the
backplane. While pulling firmly, wiggle the connector until it disconnects from the
backplane. It may take some force to disconnect the connector.
Power supply
Two, two-pin
connectors
to the fans