License Plate Lamp; Replacement Bulbs - Chevrolet 2009 Uplander Owner's Manual

8. Reinstall the taillamp assembly by inserting the
outboard locating/retaining pins until the lamp is
seated.
9. Secure with the inboard screws.

License Plate Lamp

To replace one of these bulbs:
1. Remove the two screws holding each of the license
plate lamps to the fascia.
2. Turn and pull the license plate lamp forward
through the fascia opening.
3. Turn the bulb socket counterclockwise and pull the
bulb straight out of the socket.
4. Push the new bulb into the bulb socket and turn it
clockwise to lock it into place.
5. Push and turn the license plate back through the
fascia opening.
6. Reinstall the two screws holding the license plate
lamps to the fascia.

Replacement Bulbs

Exterior Lamp
Back-up
Front Turn Signal, DRL and
Parking
High-Beam and Low-Beam
Headlamps
License Plate Lamp
Sidemarker
Stoplamp, Taillamp and Turn
Signal
For replacement bulbs not listed here, contact your
dealer/retailer.
Bulb Number
3057KX
3157NAK
H11
168
194
3057KX
5-45