Remote Power Sliding Door Operation; Programming Transmitters To The Vehicle - Chevrolet 2009 Uplander Owner's Manual

To unlock all doors the first time
"FOB UNLOCK ON 1ST PRESS" under DIC Vehicle
Personalization (Uplevel Only) on page 3-68.
"
Pressing may disarm the content theft-deterrent
system if the vehicle has one. See Content
Theft-Deterrent on page 2-27.
L
(Remote Alarm): Press to sound the alarm. The
turn signal lamps flash and the horn sounds. Press
L
again to turn off the alarm.

Remote Power Sliding Door Operation

+
(Power Sliding Door): For vehicles with a
power sliding door, press and hold
the power sliding door. See Power Sliding Door (PSD)
on page 2-16.
* +
(Dual Power Sliding Doors): For vehicles
with dual power sliding doors, press and hold
to open or close the driver side door or
close the passenger side door. See Power Sliding
Door (PSD) on page 2-16.
2-6
"
is pressed, see
+
to open or close
*
+
to open or
Operating the power sliding door(s) with the RKE
transmitter occurs if the power sliding door override
switch(es) on the overhead console are active or
inactive. See Power Sliding Door (PSD) on page 2-16
for additional information.
If the sliding door is closed and the power sliding door
button on the transmitter is pressed and held, the
vehicle's doors unlock and then the power sliding door
opens. If the power sliding door has been locked
using the manual door lock lever, the power sliding door
must be unlocked before it can be opened with the
RKE transmitter sliding door button.
If the vehicle's fuel filler door is opened, the driver side
power sliding door will not open completely. Do not
try to force the door. Once the fuel filler door is closed,
the driver side sliding door can be opened normally.
Programming Transmitters to the
Vehicle
Only RKE transmitters programmed to this vehicle will
work. If a transmitter is lost or stolen, a replacement
can be purchased and programmed through your
dealer/retailer. When the replacement transmitter is
programmed to this vehicle, all remaining transmitters
must also be reprogrammed. Any lost or stolen
transmitters will no longer work once the new transmitter
is programmed. The vehicle can have a maximum of
four transmitters programmed to it.